beautypg.com

Configuration commands, B.6.2 configuration commands, B.6.1.11 a – Comtech EF Data UT-4579 User Manual

Page 72: B.6.2 c, B.6.2.1 f

background image

UT4579 X-Band Up Converter

MN/UT4579.IOM

Remote Control

Rev. 0

56

B.6.1.11 A

PPLICATION

I

DENTIFICATION

The Application Identification (AID) command allows a free form message to be created.
It is intended to identify either the satellite, transponder, beam, destination or other
aspects of the application that may be significant to operations.
The message length corresponds to capability of the LCD and is 48 characters in total.
The second line begins at character 25, therefore, blanks must be used after line 1
information in order to space to line 2. A carriage return ends the command. Trailing
blanks will be generated to fill the LCD field. The AID display will alternate with the
Equipment type display by use of the clear function key on the front panel. The default is
"AID MESSAGE".

Command

Details

Application ID:

Confirmation: >DEV/AID_'cr'

xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']

Retrieve ID:

Confirmation: >DEV/AID_'cr'

xxxxxxxxxxxxxxxxxxxxxxxx'cr'
xxxxxxxxxxxxxxxxxxxxxxxx'cr''lf']

Note: xxxxxxx ... xxxxx = Your message, maximum 48 characters.

B.6.2 C

ONFIGURATION

C

OMMANDS

B.6.2.1 F

REQUENCY

The default is RF

Low

MHZ (e.g.; 7900.000 MHZ for Model UT-4579).

Command

Details

Set Frequency:

Confirmation: >DEV/FRE_xxxxx.xxx'cr''lf']

Retrieve Frequency:

_'cr'

Confirmation: >DEV/FRE_xxxxx.xxx'cr''lf']

Note: For example, xxxx.xxx = 7900.000 to 8400.000 MHZ in 125 KHz steps for Model UT-

4579.