Comtech EF Data IPSat GW1000 - Manual (Page 36)

01-0945-401 Rev. A 08/2004 26
Main Menu → Utilities →
Loopback → Test Statistics
DVB Receive Packets: The number of
packets received at the DVB port during
loopback testing.
HDLC Transmit Packets: The number of
packets transmitted out of the HDLC port
during loopback testing.
Main Menu → Utilities →
Initialize Configuration
Answering Yes will return all of configured
settings to their factory default values.
Main Menu → Utilities →
Firmware Upgrade
When new features are added or "bugs" are
fixed, a firmware upgrade is required. The
firmware can be downloaded to the IPSat
GW1000 using the console interface or your
provider may choose to download it through
the DVB stream. For the fastest console
download, the console port speed should be
set to 115200 bps and 1K X-MODEM should
be used as the transfer protocol. Note: While
a firmware upgrade is being downloaded, the
IPSat GW1000 will not forward any network
traffic.
Main Menu → Utilities →
Debug Commands →
Forward Channel Processor
Commands
This is a debugging tool and should only be
used under the direction of Radyne
ComStream customer support.
Main Menu →
Utilities →
Debug Commands →
Packet Capture Commands →
Packet Capture Control Enables or disables the capturing of the last
XXX packets the IPSat GW1000 received on
its Ethernet port.
Main Menu →
Utilities →
Debug Commands →
Packet Capture Commands →
View Packet Capture Decodes the packets captured by the IPSat
GW1000.
Main Menu →
Utilities →
Debug Commands →
Packet Capture Commands →
Erase Packet Capture Answering “Y” erases from non-volatile
memory the packets captured by the IPSat
GW1000.
Main Menu →
Utilities →
Debug Commands →
Packet Capture Commands →
Save Packet Capture Answering “Y” saves the packets captured by
the IPSat GW1000 to non-volatile memory.
Main Menu →
Utilities →
Reset Answering “Y” will cause IPSat GW1000 to
reset.