Comtech EF Data IPSat GW1000 User Manual
Page 32
01-0945-401 Rev. A 08/2004
22
Main Menu
→
Configuration
→ Advanced
→ DVB/MPEG → PID
Table
When a PID (Program Identifier) value is
entered, the IPSat GW1000 will accept and
process all traffic received by the DVB port
(demodulator or receive port) that contains
the PID value. At least one PID must be
entered to receive DVB traffic and is defined
by your service provider.
Main Menu
→
Configuration
→ Advanced
→ DVB/MPEG → MAC
Filtering
Enables or disables MAC Filtering. When
MAC Filtering is enabled, only DVB packets
containing the IPSat GW1000's MAC address
will be accepted and processed by the IPSat
GW1000. This value is usually defined by
your service provider.
Main Menu
→
Configuration
→ Advanced
→ DVB/MPEG →
Audio/Video
[1] Video PID: When a Video PID
(Program Identifier) value is entered, the
IPSat GW1000 will accept and process all
traffic received by the DVB port
(demodulator or receive port) that contains
the PID value. The MPEG-2 video traffic
that is received on this PID will be output on
the RCA Video output (J82).
[2] Audio PID: When an Audio PID
(Program Identifier) value is entered, the
IPSat GW1000 will accept and process all
traffic received by the DVB port
(demodulator or receive port) that contains
the PID value. The MPEG-2 audio traffic
that is received on this PID will be output on
the RCA Audio Left and Right outputs (J80
and J81).
[3] PCR PID: When a PCR
(Programmable Clock Reference) PID
(Program Identifier) value is entered, the
IPSat GW1000 will accept and process all
traffic received by the DVB port
(demodulator or receive port) that contains
the PID value. In most cases, the PCR PID
must match the video PID so that the MPEG-
2 video stream can be properly decoded.
Main Menu
→
Configuration
→ Advanced
→ Console
The console port speed Default is
19200,8,N,1 Note: baud rate is in bps (bits
per second).
Main Menu
→
Configuration
→ Advanced
→ Security → Telnet
Control
Enables or disables the IPSat GW1000's
Telnet server. Default is Disable. Only
six Telnet sessions can be active at any
given time.
Main Menu
→
Configuration
→ Advanced
→ Security →
Telnet/Console Password
The Telnet password can be entered here.
Default is IPSat GW1000. Should be
changed to a unique password for security
reasons.