Comtech EF Data IPSat GW1000 - Manual (Page 35)

01-0945-401 Rev. A 08/2004 25
[HDLC] Transmitted Packets: Number
of packets that are transmitted out of the
HDLC port.
[HDLC] Transmission Errors: Number
of errors that occur when attempting to
transmit packets out of the HDLC port.
Mpeg Packet Total: Number of packets
received in the MPEG/DVB stream.
Mpeg Packet Errors: Number of errors
received in the MPEG/DVB stream. It is
normal for a few errors to appear upon
startup or reset.
Main Menu → Status →
Firmware Versions
Displays the versions of firmware that are
used by the IPSat GW1000.
Main Menu →
Status →
Faults →
Current Faults Any active faults will appear on this screen.
For a description of faults, please refer to the
Faults and Maintenance chapter.
Main Menu →
Status →
Faults →
Fault Log The last 100 faults will appear on this screen
along with the time the fault occurred, since
the last reset. For a description of faults,
please refer to the Faults and Maintenance
chapter.
Main Menu → Utilities →
Ping
[1] Destination IP Address: The IP
address of the host that is to be pinged.
[2] Packet size: The size of the payload
contained in the ping.
[3] Number of packets: The number of
packets to send to the host.
[4] Send Ping(s): Initiates the ping
process. Pressing the ESC key will abort the
ping task.
Main Menu → Utilities →
Loopback → Test
[1] Loopback IP Address: The IP
address that the IPSat GW1000 will send
back through its HDLC port.
[2] Loopback Test (Hardware): Starts
or stops the loopback mode.