Comtech EF Data IPSat GW1000 - Manual (Page 29)

01-0945-401 Rev. A 08/2004 19
The easiest way to configure the IPSat
GW1000 for this network is to perform the
following three steps:
1. Configure a default gateway of 10.0.0.30
on the Basic Configuration page. Using the
default gat
gateway in this instance saves the user from
entering ten static routes.
2. Configure a static route as follows:
Destination: 192.168.34.240
Mask: 255.255.255.248
Gateway: 10.0.0.35
Port: Ethernet
3. Configure a static route as follows:
Destination: 192.168.34.232
Mask: 255.255.255.248
Gateway: 10.0.0.40
Port: Ethernet
Main Menu →
Configuration → Advanced
→ Network → ARP
Determines how long an unused ARP
(Address Resolution Protocol) entry will
remain in the ARP table.
Main Menu →
Configuration → Advanced
→ Network → HDLC
This value depends on the type of equipment
your service provider is using to process the
IPSat GW1000’s HDLC (transmitted) traffic.
16-bit address mode is used for Cisco
equipment and 0-bit address mode is used for
RAD equipment. Your service provider
should provide you with this setting.
Main Menu →
Configuration → Advanced
→ Network → NMS
Control Address
The IP address that is used by your service
provider's NMS (Network Management
System). The NMS allows your service
provider to configure your IPSat GW1000
and gather statistics from your IPSat
GW1000.
Main Menu →
Configuration → Advanced
→ MODEM → Modulator
[1] MI - TX Spectral Inversion:
Enables or disables transmit spectral
inversion. Default is Disable
[2] TM - TX Modulation Type:
Modulation type can be set to QPSK or
BPSK. This should be provided by your
service provider. Default is QPSK.
[3] TO - TX Offset: A frequency that is
added (or subtracted) to the TX frequency.
Default is 0hz.
[4] ROE - Radio Output Enable: The
amount of time that the IPSat GW1000 will
wait upon power-up or reset to automatically
enable the modulator. The BUC requires a
warm-up period in order for accurate
transmission characteristics. Default is 180
seconds.
[5] TR - TX Symbol Rate: The symbol
rate at which the modulator transmits at.