Comtech EF Data IPSat GW1000 - Manual (Page 22)

12
01-0945-401 Rev A 08/2004
Front Panel Operation
This section describes the feedback system of the IPSat GW1000 front panel:
Front Panel Components
The front panel is broken into the following sections:
Status
• Power: Illuminates green when powered on
• Fault: Illuminates red when a fault is active
• Tx Enabled: Illuminates green when the modulator is enabled
• Ethernet Speed: Illuminates green when speed is 100mbps. Illuminates orange when speed is
10mbps.
• Ethernet Duplex: Illuminates green when duplex is full. Illuminates orange when duplex is half.
RF Signal (Eb/No)
• Max: Illuminates green if Eb/No is 11 or above
• . : Illuminates green if Eb/No is 10 or above
• . : Illuminates green if Eb/No is 9 or above
• . : Illuminates green if Eb/No is 8 or above
• Min: Illuminates green if Eb/No is 5 or above
• Sync: Illuminates green if demodulator has achieved synchronization
Activity (Rx)
• Max: Illuminates yellow if 90% of Rx Subscribed BW is above or is being utilized
• . : Illuminates green if 80% of Rx Subscribed BW or above is being utilized
• . : Illuminates green if 70% of RX Subscribed BW or above is being utilized
• . : Illuminates green if 60% of Rx Subscribed BW or above is being utilized
• . : Illuminates green if 50% of Rx Subscribed BW or above is being utilized
• Min: Illuminates green if 1% of RX Subscribed BW or above is being utilized
Activity (Tx)
• Max: Illuminates yellow if 90% of Tx Data Rate or above is being utilized
• . : Illuminates green if 80% of Tx Data Rate or above is being utilized
• . : Illuminates green if 70% of Tx Data Rate or above is being utilized
• . : Illuminates green if 60% of Tx Data Rate or above is being utilized
• . : Illuminates green if 50% of Tx Data Rate or above is being utilized
• Min: Illuminates green if 1% of Tx Data Rate or above is being utilized