Comtech EF Data IPSat GW1000 - Manual (Page 26)

01-0945-401 Rev. A 08/2004 16
frequency in Hz (hertz) that the demodulator
receives at and is usually defined by your
service provider.
[8] TC - TX Coding Rate: Sets the
coding rate that the modulator will use and is
usually defined by your service provider.
[9] TD - TX Data Rate: Sets the data rate
in bps (bits per second) that the modulator
transmits at and is defined by your service
provider. The TX Symbol Rate is
automatically determined by the TX Coding
Rate and the TX Data Rate.
[10] TS - TX Frequency: Sets the
frequency in Hz (hertz) that the modulator
transmits at and is usually defined by your
service provider.
[11] TP - TX Power Level: Determines
the power level in dBm (decibel-meter) that
the modulator transmits at.
[12] EM - Modulator: Enables or
disables the modulator. It performs the same
function as pressing TX Enable on the front
panel.
[13] HP - 10 MHz Reference: Enables or
disables the 10 MHZ reference from the
IPSat GW1000 to the BUC (Block Up
Converter)
[14] MIV - 24 Volt Output: Enables or
disables the 24v output from the IPSat
GW1000 power supply to power a BUC
(Block UpConverter). The output supplies a
maximum of 3 Amps.
[15] AE - Modulator Auto Enable:
Used to automatically enable the modulator
upon power-up or reset when set to Auto;
otherwise, when set to manual, the modulator
must be manually enabled upon power-up or
reset.
[16 ] PC - Pure Carrier: Enables or
disables the transmission of an unmodulated
carrier (continuous wave) out of the
modulator. The pure carrier signal is used for
diagnostic and installation procedures.