Comtech EF Data MIDAS Version 4.X NMS Configuration - Manual (Page 139)

MIDAS 4.X NMS Configuration, Rev. 6
Frequency Translation A-7
Figure A-4. Ku-Band Control Channel Setup Example
After Control Channel and LinkSync  parameters are set, allow the Controller to reboot.
The Controller will reinitialize with the new parameters and run a self-test. If the self-test
does not pass, recheck the parameters for System Administration Satellite, Transponder,
Satellite, Control Channel, and LinkSync
. Also verify Bandwidth Administration Space
Segment.
Figure A-5. MIDAS Ku-Band Space Segment Example
Right click within the Public Pool and select Add Bandwidth, observe the 2.4 MHz
segment Start and End frequencies for IF, L-Band, RF RX, RF TX, and Channels. Each
Channel represents one unit of the selected Step Size (2.5 kHz in this case).