Comtech EF Data KST-12025 - Manual (Page 77)

Rev. 1 4–1
4
Chapter 4.
OPERATION
This chapter provides the following information:
•
System operation
•
Remote control
•
Front panel display/keypad operation
4.1 System Operation
There are three methods of operating the RFT-1225:
•
Connect a PC running DOS to the EIA-232-C/485 remote control port, and run
the M&C system monitor software. This software is DOS-based and provides an
interface to the remote commands.
For information on the remote commands, refer to Appendix A.
For more information on the M&C system monitor program, refer to the EFData
Monitor and Control Software for EFData Satellite Terminals User’s Guide.
•
Connect the optional KP-10 hand-held keypad. For more information, refer to
the EFData KP-10 External Keypad Installation and Operation Manual.
•
Use the optional front panel display/keypad (refer to Section 4.3).