beautypg.com

Applications, Monitor and control – Comtech EF Data KST-12025 User Manual

Page 20

background image

Introduction

KST-12025 Ku-Band Satellite Terminal

1–4

Rev. 1

1.1.1 Applications

When used in conjunction with EFData modems, the KST-12025 terminal is ideal for:

Single digit carriers

Multiple carrier operation over a 36 MHz bandwidth

Because the terminal has a 70 MHz IF, it can also be used for other analog and digital
applications.

Small-to-medium size earth stations are easily constructed and commissioned with the
terminal.

When used with a high-gain antenna, the KST-12025 can also be used as the Radio
Frequency (RF) electronics of a central hub in point-to-multipoint applications, as well
as serve as the terminal for the end points of the network.

1.1.2

Monitor and Control

An on-board microcomputer monitors and controls all operational parameters and system
status of the KST-12025. This powerful M&C system enables the user to locally or
remotely control functions such as:

Output power

Transmit/receive channel frequencies

The system also reports terminal configuration status, as well as fault status of all
KST-12025 components.

The terminal can be initially configured by a keyboard/LCD controller within the
enclosure, or by connection of a common ASCII/RS-232 terminal connected to the serial
port. A simple command set allows total configuration control and retrieval of status
information.

If the indoor unit is a more sophisticated station monitor and control computer, the serial
port can be set to RS-485 for bus operation.

For more information on the M&C board, refer to Chapter 5.