Comtech EF Data KST-12025 - Manual (Page 73)

KST-12025 Ku-Band Satellite Terminal Redundant System Installation
Rev. 1 3–19
4. Using four 6-32 x 7/8” socket head cap screws, eight #6 flat washers, four #6
split lockwashers, and four 6-32 nuts, attach the LNA to the antenna waveguide.
Tighten the cap screws firmly.
3.3.5 Waveguide Switch Installation
The following process is for a typical installation. Custom systems may be ordered, and
are beyond the scope of this manual.
An installed waveguide switch is shown in Figure 3-2. Refer to Section 3.2.1 for
included parts.
Figure 3-2. Installed Waveguide Switch