Comtech EF Data KST-12025 - Manual (Page 46)

Single Thread System Installation KST-12025 Ku-Band Satellite Terminal
2–16 Rev. 1
c. Install a 5/16” flat washer, 5/16” split lockwasher, and 5/16-18 nut on each
threaded rod.
d. Position the RFT as desired, and tighten the 5/16-18 nuts installed in
Step 6.c.
e. Slide the pipe blocks inward until they contact the vertical pole, then firmly
tighten the 5/16-18 bolts.
2.3.2.2 Square Pole
For square vertical pole installation, follow the steps in Section 2.3.2.1, with the
following exceptions:
•
Do not perform Step 4.
•
Do not perform Step 6.e.