Comtech EF Data KST-12025 - Manual (Page 37)

KST-12025 Ku-Band Satellite Terminal Single Thread System Installation
Rev. 1 2–7
2.3 RFT Installation
At the customer’s discretion, the RFT can be installed anywhere on or near the antenna.
The supplied hardware allows the installer a wide range of installation alternatives,
including:
•
Vertical pole (e.g., mast) (either square or round). This is the most typical
installation.
•
Within the hub of a large antenna.
•
Spar (i.e., square bar) on the antenna structure.
EFData recommends that the RFT be mounted vertically, with the air inlet facing the
ground.