Comtech EF Data CST-5005 - Manual (Page 41)

CST-5005 C-Band Satellite Terminal Single Thread System Installation
Rev. 1 2–19
2.5 External Connections
Connections between the RFT and other equipment are made through six connectors.
These connectors are listed in Table 2-1, and their locations are shown in Figure 2-1.
The use of each connector is described in the following paragraphs.
Table 2-1. Front Panel Connectors
Name Ref. Design. Connector Type Function
TX/IF IN J1 Type N TX IF INPUT (70 MHz)
TX/RF OUT J2 Type N 5.845 to 6.425 GHz Out
RX/IF OUT J3 Type N RX IF OUT (70 MHz)
RX/RF IN J4 Type N 3.620 to 4.200 GHz Input
PRIME PWR J5 Standard Prime Power Input
REMOTE J6 26-pin CIR Remote Interface
GND ERDE GND #10-32 Stud Chassis Ground
Figure 2-1. RFT-505 External Connections