Comtech EF Data CST-5005 - Manual (Page 31)

CST-5005 C-Band Satellite Terminal Single Thread System Installation
Rev. 1 2–9
2.3.2 Vertical Pole Installation
2.3.2.1 Round Pole
Note: The following process is for a typical installation. Custom systems may be
ordered, and are beyond the scope of this manual.
To install the RFT to a round vertical pole:
1. Set the unit on its side, with the mounting holes facing up.
2. Install the two 14” unistruts as follows:
a. Position a 14” unistrut (with
the open side facing up)
over one set of the mounting
holes on the RFT.
b. Using four 1/4-20 bolts,
1/4” split lockwashers, and
1/4” flat washers, attach the
14” unistrut to the RFT.
Tighten the bolts firmly.
c. Repeat Steps 2.a. and 2.b.
for the second 14” unistrut.