DMP Electronics XR2500F - Manual (Page 35)

XR2500F Installation Guide Digital Monitoring Products
27
InstallatIon
J1 Ethernet Connector
22.1 Description
The J1 Ethernet Connector is available to connect directly to an Ethernet network using a standard patch
cable. The maximum line impedance is 100 Ohms.
J1
Ethernet
Link LED
Activity LED
Figure 15: J1 Header and LEDs
22.2 Ethernet LEDs
The two LEDs, located to the left of J1 Ethernet Connector, indicate network operation. The top, Activity
LED flashes green to indicate the network traffic is good. The bottom, Link LED flashes yellow to indicate
messages are being sent and received.
Reset and Tamper Headers
23.1 J16 Reset Header
The reset header is located just above the terminal strip on the right side of the circuit board and is used
to reset the XR2500F microprocessor. To reset the panel when first installing the system, install the reset
jumper before applying power to the panel. After connecting the AC and battery, remove the reset jumper.
To reset the panel while the system is operational, for example, prior to reprogramming, install the reset
jumper without powering down the system. Remove the reset jumper after one or two seconds.
After resetting the panel, begin programming within 30 minutes. If you wait longer than 30 minutes, you
must reset the panel again.
J6
Interface
Card
Expansion
Connector Momentarily place the Reset
jumper over both of the J16
pins to reset the panel.
AC
1 2 3 4 5 6 7 8 10 11 12 13 14 15 16 17 18 19 9 20 21 22 23 24 25 26 27 28
+B BELL GND SMK GND RED YEL GRN BLK Z1 Z2 Z3 Z4 Z5 Z6 Z7 Z8 Z9+ Z9– Z10+ Z10– AC –B GND GND GND GND
K6 K7
Output 1 Output 2
J3
Phone Line
J10
J22
LX-Bus
Battery
Start
J23
J21
RS-232
Power
LED
J8
PROG
J4
Tamper
J16
Reset
Out
1
O
ut
2
Outputs 3-6
J11
3
4
5
6
J2
J1
Ethernet
R
L
X
OVC
Link LED
Activity LED
Figure 16: XR2500F Panel Showing the Reset Jumper
23.2 J4 Tamper Header
The J4 header is for use with the optional DMP 306 Tamper Harness. The harness connects to one or more
tamper switches mounted inside the panel enclosure to supervise against unauthorized enclosure opening or
removal. Refer to the wiring diagram on the enclosure door for correct tamper switch wiring.
How the Tamper Works
If the enclosure is opened or removed while one or more of the system areas are armed, a panel tamper
alarm is indicated. If all areas are disarmed, a panel tamper trouble is indicated.