Avery Dennison TTX 450 - Manual (Page 7)

User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 7
Connection of External Units
A serial interface V.24/DB25 (RS232) and a parallel interface (Centronics) are
integrated as standard for connection of the printer to the computer.
Optional there is a RS 485 interface available - the RS 232 can be (factory
installed) removed and changed to a RS 485 interface. Be aware that the RS
232 interface then is removed !
The rear side of the unit is, in addition, equipped with one ore two sockets for the
connection of an external unit.
Attention: Turn off unit prior to plugging/unplugging interface cable/stacker connector
Exclusively units tested in accordance with IEC 950 and VDE 0805-which are in
compliance with these standards according to SELV- must be connected to
interface and stacker socket.
Card Plug in Modules
These plug in modules are provided for the optional font and logo cards. Use
PCMCIA cards up to a size of 2 MB only. There is a maximum of 1 logo card
alone or together with a font card – as well one or two font cards are possible.
Logo Cards and data bank cards are formatted by the printer itself.
Font cards are to be programmed by supplier only.
Attention: Exclusively plug in cards approved by the manufacturer must be used Insert,
remove, or exchange card not until 60 seconds after disconnection of unit.
SLOTS TTX
SLOT 0
SLOT 1