Avery Dennison TTX 450 - Manual (Page 30)

User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 30
Note: The screw enters a non visible gap at the axle, which ensures the correct
position of the printhead. Factory adjustment is flash with the inner black
plastic bushing.
• Before switch on the unit, check that both connectors of printhead are still
plugged on correctly. Reconnect if necessary.
Clean feed roller for single tags -
TDI / XXTREME / S TDI only-
• switch off device
Attention: Pull off mains plug!
• the feed roller should be cleaned with a dust free towel together with the
Avery roller cleaner
From time to time the separation edge and the bearings should be cleaned
Cleaning will help to extend the runtime of your device !
Attention: Cleaning of that roll on a regular basis is influencing the accuracy of the imprint
of your device. Please clean at least two times a day !
Clean Short Tag Option -
TDI / XXTREME / S TDI only-
• switch off device
Attention: Pull off mains plug!
• if the Short Tag Option is built in, you have to clean the additional feed roller
as well – use a dust free towel ad the Avery roller cleaner.
• please clean as well the pressure roller
Cleaning of Punch-Recognition Sensor
According to the materials applied, the light barriers is to be cleaned from
material residues and dust by means of compressed air.
• Disconnect unit
Attention: Pull off mains plug!