Avery Dennison TTX 450 - Manual (Page 31)

User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 31
• Remove material and ribbon.
• Loosen screw at center of printhead axle - until the printhead fixation can
be rotated clockwise.
Attention: Do not remove plugs from the printhead. If printhead is readjusted at axle mark
its position accordingly.
• After performance of this step, the sensor are accessible from above.
• Clean sensor with air pressure only.
With heavy contamination additional cleaning using a dust-free cloth and
cleansing liquor is recommended.
• Put printhead to former position and fix screw again.
Note: The screw enters a non visible gap at the axle, which ensure the correct
Position of the printhead. Factory adjustment is flash with the inner black
plastic bushing.
• Before switch on the unit, check that both connectors of printhead are still
plugged on correct. Reconnect if necessary.
Cleaning of ribbon guiding parts
Adhesive residues are to be removed at regular intervals upon processing
of self-adhesive material to ensure perfect print quality.
Clean parts with dust-free cloth and cleansing liquor only.
Contaminated parts affect the feed of the ribbon and will reduce the print
quality.
Cleaning of knifes -
TTX 650 / LION / S 65 only -
Adhesive residues are to be removed at regular intervals upon processing
of self-adhesive material to ensure perfect material cut and unwinding.
Attention: Pull of mains plug
Be aware of sharp edge of knife which could cause injury.
Remove adhesive residues from upper and lower knife; in case slightly
swivel knives for better access to the entire edge.
Clean parts with dust-free cloth and cleansing liquor only.