Avery Dennison TTX 450 - Manual (Page 21)

User Manual
TTX 450/650/950/1050 – Puma/Lion/Tiger/Tiger XXL – TDI/STDI/XXtreme –
S45/65/95/105
05/08 Rev. 2.14 21
Installation of option
for TTX 650 / LION / S 65
Attention: Some of the options – like the dispenser module can only be mounted by service
personal ! Sometimes it is necessary that a module can be imbedded only from a
defines series number – see option manual.
Unplug main power supply!
• Plug light-barrier connector and motor connector in. Both sockets are
located at front side of housing.
• Fasten unit by means of 2 hexagon socket screws at vertical base plate
of printer.
• Reconnect power supply and switch unit on.
Attention: Hazard of injury in the initialisation process and during cutting because of moving
knife!
• to activate the option go the parameter ‘PEPH’ and select the option with the
necessary parameter
• follow the steps in the option manual
A special case is the color option – therefore you have to install a separat firmware
and add an additional sensor. For more details refer to the color manual.
connecting