Avery Dennison 9850 RFID Multi-Protocol - Manual (Page 46)

A-4 Single Protocol Encoding
Print Configuration Label
The RFID configuration label displays Firmware Version, Hardware
Version, Module Type, Frequency, all the Setup, RFID Menu options,
Good RFID Tags (number of RFID tags successfully programmed since
last cleared), and Bad RFID Tags (number of RFID tags that failed
programming since last cleared).
Depending on your application and volume of labels printed, you may
want to print this configuration label daily or after each batch.
To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1. Press Å or Æ until you see
RFID
Å
Print Summary?
2. Press Enter/Pause. The configuration label prints.
3. Press Escape/Clear until you see the Main Menu.