Avery Dennison 9850 RFID Multi-Protocol - Manual (Page 27)

Setting Up the Printer 3-3
Consider this scenario when the error action is set to
overstrike/continue 3x:
If the printer errors on the first label, an overstrike pattern is printed, but
the printer attempts to reprint the image up to three times. If the third
consecutive label also generates an error, an overstrike pattern is
printed; however, the printer stops and the error message is displayed.
The operator must resolve the error condition before printing continues.
In the above example, if the third label did NOT generate an error,
♦ the batch image is printed
♦ the consecutive error counter is reset
♦ the printer continues processing the batch.
Error Action Modes
Normal (default) The printer errors and the condition causing the
error is displayed. The error must be cleared
before operation can continue. An operator must
press Escape/Clear to clear the error and continue
printing. No overstrike pattern is printed.
Overstrike/Continue 1x
Overstrike/Continue 2x
Overstrike/Continue 3x
Overstrike/Continue 4x
Overstrike/Continue 5x The printer prints an overstrike pattern on one,
two, three, four, or five consecutive labels and
stops printing after the selected number of
overstrike patterns have been printed. An operator
must press Escape/Clear to clear the error and
continue printing.
Note: The printer does not recalibrate (feed a blank label) after any
RFID error.
For more information about the error actions, see the following table.
Error Action Standard
Peel
Verifier with
Peel
RFID with
Peel
Overstrike/Continue 1-5 No No No
Normal (no overstrike) Yes Yes Yes
Note: If using the Overstrike and Continue error mode, do not use peel
mode.