Avery Dennison 9850 RFID Multi-Protocol - Manual (Page 16)

2-4 Multi-Protocol Encoding
Read Tag
Use this option to read what is programmed into an RFID tag.
To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1. Press or until you see
RFID
Read Tag
2. Lay the RFID tag you just programmed inside the supply path with the
tag’s antenna over the printer’s box antenna. (The box antenna is
located behind the platen roller.)
3. Press Enter/Pause. Data appears on the display.
If the tag cannot be read “Illegal Command” appears briefly on the
display. Try slightly moving the tag forward or back in the supply
path over the box antenna and try again.
If the tag can be read, you see whatever data was programmed,
such as
Complete
0123456789ABCDEF
The programmed data is always displayed in ASCII Hex format,
regardless of which data type was entered.
Press to scroll through the data (if using a 96-bit RFID tag).
Press Enter/Pause or Escape/Clear to return to the RFID Menu.
4. Press Escape/Clear until you see the Main Menu.