Avery Dennison 9850 RFID Multi-Protocol User Manual
Page 25
Setting Up the Printer 3-1
S E T T I N G U P T H E P R I N T E R
Use this chapter to
♦ set the supply and print positions, if necessary
♦ set the Error Action for RFID labels
♦ view the Diagnostics version information.
S e t t i n g t h e P r i n t a n d S u p p l y P o s i t i o n s
Do not modify the Supply Position when using RFID supplies greater
than a two-inch feed length. Doing so may move the RFID tag out of
the RF Field’s readable and programmable range. If necessary, you can
modify the Print Position; however, make sure you do not move the tag
out of the readable and programmable range.
When using RFID supplies with a one-inch feed length, see the table in
Chapter 2, “Multi-Protocol Encoding,” for the Supply and Print Position
settings. (From the Main Menu, select Setup, Supply, Positioning, then
select Print Position and Supply Position.)
U s i n g t h e S e t u p S u p p l y M e n u
MAIN MENU
3
D i s p e n s e
P o s i t i o n
K n i f e
C o n t r o l
B a c k f e e d
D i s t a n c e
S e p a r a t o r s
S k i p I n d e x
E r r o r A c t i o n
S e t u p
S u p p l y
S u p p l y T y p e
B a c k f e e d
R i b b o n
S p e e d
F e e d M o d e
P o s i t i o n i n g