Avery Dennison 9850 RFID Multi-Protocol - Manual (Page 21)

Multi-Protocol Encoding 2-9
Print Configuration Label
The RFID configuration label displays the module’s Firmware and
Hardware Versions, Module Type, Frequency, all the Setup, RFID Menu
options, Good RFID Tags (number of RFID tags successfully programmed
since last cleared), and Bad RFID Tags (number of RFID tags that failed
programming since last cleared).
Depending on your application and volume of labels printed, you may
want to print this configuration label daily or after each batch.
To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1. Press or until you see
RFID
Print Config
2. Press Enter/Pause. The configuration label prints.
If the Module Type on your label displays “Alien,” see Appendix A,
“Single Protocol Information,” for more information.
You can also display the Firmware and Hardware Versions using
the Diagnostics Menu. See “Version Information,” in Chapter 3
for more information.
3. Press Escape/Clear until you see the Main Menu.