Avery Dennison 9850 RFID Multi-Protocol - Manual (Page 10)

1-4 Getting Started
FCC RF Exposure Guidelines
To comply with FCC exposure requirements, antennas that are mounted
externally at remote locations or operating near users at stand-alone
desktop of similar configurations must operate with a minimum separation
distance of 20 cm from all persons.
Declaration of Conformity for RF Exposure:
The radio module has been evaluated under FCC Bulletin OET 65C and
found compliant to the requirements as set forth in CFR 47 Sections
2.1091, 2.1093, and 15.247 (b) (4) addressing RF Exposure from radio
frequency devices.
Radio Frequency Interference Requirements
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference that may
cause undesired operations.
CAUTION: The Part 15 radio device operates on a non-interference
basis with other devices operating at this frequency when
using the listed antenna.
If the equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
♦ Re-orient or relocate the receiving antenna.
♦ Increase the separation between the equipment and receiver.
♦ Connect the equipment into an outlet on a circuit different from that
which the receiver is connected.
Collocation Statement:
This device must not be collocated with any other antenna or
transmitters.