beautypg.com

Installation, Fireplace placement requirements, For qualified installers only) – Avalon Firestyles DVL Fireplace-1999 to 2002 User Manual

Page 9: Travis industries, Minimum framing dimensions

background image

Installation

(for qualified installers only)

7

Travis Industries

4 0 2 0 8 1 2

9 3 5 0 8 1 1 0

Fireplace Placement Requirements

Minimum Framing Dimensions

The 1” stand-offs along the sides and rear, the 1” clearance requirement around the sides and back,
and the 7-1/4” stand-offs on the top of the fireplace separate the fireplace from combustible materials
(e.g.: combustible framing members, plywood, sheetrock, paper-backed insulation). The stand-offs
may contact the framing members but no material may be placed between the stand-offs or into the
required 1” clearance to the sides and back.

This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance
produces when determining a location.

84-1/2" Min.

44-1/4"

20-1/2"

46-3/4"

NOTE: if venting directly to the rear, make sure
there is a min. 12" space centered behind the
fireplace. The firestop included with this fireplace
requires a 14" tall by 12" wide opening.

3" Clearance Min. Above Vent

The center of the vent is a minimum 70-1/2"
above the base of the fireplace (includes 24"
min. rise before elbow - see the section
"Horizontal Termination Requirements")

2" Clearance Min. to
the Sides of Vent

The fireplace enclosure
must not be less than
84-1/2" above the base
of the fireplace.

Top Vent Configuration

1" Clearance Min.
Below Vent

46-3/4" Min.

44-1/4"

20-1/2"

46-3/4"

NOTE: if venting directly to the rear,
make sure there is a min. 13" space
centered behind the fireplace.

3" Clearance Min. Above Vent

The center of the vent is 34-
1/4" above the base of the
fireplace (see the "Rear Vent
Configuration")

1-1/2" Clearance Min.
to the Sides of Vent
and Below Vent

The fireplace enclosure
may be framed over
the top stand-offs
(applies to the Rear
Vent Configuration
only).

Rear Vent Configuration

Fireplace must be installed on a level surface capable of supporting the fireplace and vent

Fireplace must be placed directly on wood or non-combustible surface (not on linoleum or carpet)

Due to the high temperature of the fireplace, it should be located out of traffic and away from furniture
and draperies.