Avalon Firestyles DVL Fireplace-1999 to 2002 - Manual (Page 33)

Installation
(for qualified installers only)
3 1
Travis Industries
4 0 2 0 8 1 2
9 3 5 0 8 1 1 0
Electrical Connection
! Make sure the household breaker is shut off prior to working on any electrical lines.
! The appliance, when installed, must be electrically grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical Code, ANSI NFPA 70, or the Canadian Electrical
Code, CSA C22.1.
• The electrical line must comply with all applicable codes and supply 120 Volts at 60 Hz (2 Amps).
• Follow the directions below to connect power to the fireplace.
a b
Insert the sheathed cable from the power source through
this cable clamp. Once the wires are attached, tighten
the clamp to secure the cable.
Replace
the cover
removed
in step "a".
Attach the common (white), ground (exposed or green) wires, and hot
(black) wires from the power source to the electrical connector (attached
to the fireplace).
c
d
Standard
Screwdriver
Remove the cover from the
fireplace junction box.
1/4" Nutdriver
Electrical
Connector
WARNING: Make sure power is
off from the power lead before
conducting any wiring.