Avalon Firestyles DVL Fireplace-1999 to 2002 - Manual (Page 46)

4 4
Safety Label
Travis Industries 4 0 2 0 8 1 2 9 3 5 0 8 1 1 0
The safety (listing) label is on a
plate chained to the gas
control valve. A copy of the
safety label is shown to the
right.
Travis Industries, Inc.
DVL Z.C. Fireplace
Vented Gas Fireplace Heater (Direct V
ent)
Te
sted and certified by OMNI-T
est Laboratories, Inc. to the combustion performance and construction requirements of
ANSI Z21.88
/CSA
2.33-1998, applicable sections of UL
307b and
CAN/CGA
2.17-M91.
Must be installed in accordance with all local codes, if any; if not, in USA
follow
ANSI Z223.1-1992 and NFP
A
54(88), in Canada C
AN/CGA
B-149. Installation in Manufactured or
Mobile Homes must conform with: In USA, Manufactured Home Construction and Safety Standard, T
itle 24 CFR, Part 3280; In Canada,
CSA
Z240.4 and Gas-Equipped
Recreational V
ehicles and Mobile Housing. This appliance is only for use with the type of gas indicated on the rating plate and
may be installed in an aftermarket, permanently
located, manufactured (mobile) home where not prohibited by local codes. See owner
’s manual for details. This appliance is not
convertible for use with other gases, unless a
certified kit is used. This appliance uses a millivolt-type control system consisting of a gas control valve/regulator
, a stand
ing pilot burner assembly
, a thermopile, a piezo ignitor
,
and the ON/OFF switch. THIS UNIT DOES NOT REQUIRE 1
10 VOL
T POWER T
O
OPERA
TE.
All exhaust gases must be vented outside the struc
ture of the living-area. Combustion
air is drawn from outside the living-area structure. The DVL
Z.C. is designed to operate on natural gas, or propane (LPG). This
appliance is factory set for use with Natural Gas.
For conversion to Propane (LPG) use factory supplied kit. See owner
’s manual for information on making these changes.
W
ARNINGS:
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the informa
tion in the owner
’s and installation manual
provided with this appliance. For assistance or additional information consult a qualified installer
, service agency or the gas
supplier
.
Installation and repair should be performed by a qualified service person. The appliance should be inspected before use and at
least annually by a qualified service person.
More frequent cleaning may be required where excessive lint from material like carpeting and bedding is present. The control co
mpartment, the burner compartment and all
circulating air passageways of the appliance must be kept clean and clear at all times. Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies. This appliance must not be connected to a chimney flue servicing a separate solid fuel burning appliance. This vented gas fireplace heater is not for use with air filters. Operation of this appliance when not connected to a properly installed and maintained venting system can result in carbon monox
id
e
(CO) poisoning and possible death.
Children and adults should be alerted to the hazards of high surface temperature and should stay away to avoid flesh burns or c
lothing ignition.
Young children should be carefully supervised at all times when they are in the same room as the appliance.
This appliance is a V
ented Gas Fireplace Heater
. Not for use with Solid Fuel.
CAUTION: Hot while in operation. Do not touch. Keep children, clothing, furniture, gasoline and other liquids having flammable
vapors away
.
Do not operate this appliance with glass removed, cracked or broken. Replacement of the panel(s) should be done by a licensed o
r qualified service person.
All safety screen or guard components removed for servicing, must be replaced prior to operating the appliance. Clothing or other flammable material should not be placed on or near the appliance. Risk of electrical shock. Switch the household breaker off or remove fuse before servicing unit. Use Simpson DURA-VENT direct vent system (Model GS), or T
ravis direct vent system (Model 10-DV), to vent this appliance to the
exterior (direct discharge only without duct connection).
10850 1
17th Pl. N.E. Kirkland, W
A
98033
Minimum Clearances to Combustibles
Faceplate to
Adjacent W
all
. . . . . . . . . . .
6” (155mm)
Hearth Extension in Front - 12” (305mm), 0” (0mm) if Fireplace Raised
3” (76mm)
W
ood Floor Beneath Fireplace
. . . . . . . .
0” (0mm)
Hearth Extension to Sides of Faceplate
. . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . .
0” (0mm)
Back to enclosure
. . . . . . . . . . . . . . . . . . .
1” (25mm)
Sides to enclosure
. . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
1” (25mm)
Top to enclosure (from stand-offs)
Faceplate to Mantel
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . .
24” (610mm)
with V
ertical V
ent,
. . . . . . . . . . . . . . .
37 7/8” (960mm)
Faceplate T
op Facing
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
18”(456mm)
with Horizontal V
ent
. . . . . . . . . . . . .
0” (0mm)
Flue V
ent
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . See Owner
’s Manual
* See Owner
’s Manual For
Additional Mantel Clearances and Options.
FAN TYPE VENTED CIRCULA
T
O
R
Blower Electrical Rating: 115 V
., 1.5
Amps, 60 Hz, 150 watts
NG
LP
Output Capacity Rating
. . . . . . .
Up to
28,800
29,200
(blower on)
L.P
.
N.G.
L.P
.
N.G.
Input Rate on “HI” (BTU/Hr)
............
40,000
40,000
Minimum Inlet Pressure (inches W
.C.)
...............
11.5”
5.5”
Input Rate on “LO” (BTU/Hr)
...........
19,000
19,000
Maximum Inlet Pressure (inches W
.C.)
..............
13”
7”
Maximum Output (BTU/Hr)
..............
29,200
28,800
Manifold Pressure on “HI” (inches W
.C.)
..........
11
”
3.5”
Main Burner Orifice (DMS)
..............
#49
#31
Manifold Pressure on “LO” (inches W
.C.)
.........
2.7”
1”
This appliance is equipped for installation in Canada at 0-4500 ft. (0-1370 m); in USA, 0-2000 ft. (0-610 m). In USA, for altitudes above 2,000 feet, the vent configuration, orifice, or combination of both may need to be changed. See the owner
’s
manual for information on making these changes.
Manufacture
1999
Jan.
Apr
.
Jul.
Oct.
Date:
2000
Feb.
May
Aug.
Nov
.
2001
Mar
.
Jun.
Sep.
Dec.
IGN
Report No. 028-S-23-5