Avalon Firestyles DVL Fireplace-1999 to 2002 - Manual (Page 35)

Finalizing the Installation
(for qualified installers only)
3 3
Travis Industries
4 0 2 0 8 1 2
9 3 5 0 8 1 1 0
? If converting this unit to propane, do so now (see the instructions on page 46).
2 Install the rock wool, log set, kibbles, and embers (if using the decorative fireback, install it prior to the
log set - page 51).
Warning: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
Place the ember strips on
the grate as shown in this
illustration. The front
strip should hang half
way over the burner.
Grate
Place the log set on the
grate. Position the logs
so the rear corners rest
against the log stops.
Place the optional kibbles
in front of the firebox. Do
not place the kibbles directly
over the burner holes.
One Strip Approximately
7-1/2” by 1-1/2”
Two Strips Approximately
3” by 1-1/2”
Preparing the Metallic Wool Ember Strips (Optional):
The metallic wool comes in a single piece. Stretch the wool
as thin as possible (nearly transparent) to form three strips
of the following sizes:
There may be extra material -
save it for future use.
Side View
Tuck the front of the ember strip down, behind the burner with a
screwdriver. Make sure the mat of ember wool is not over the burner
holes. Tuck it behind the burner tube if necessary.
Note how only a few
“whiskers” are over
the burner holes.
Embedding Embers into the Front Log (optional)
Repeat this process to embed several
fibers into the log material.
Front Log
Directly Above
Front Burner
Metallic Wool
Fibers
Pull off a thin mat of metallic wool. Place it in front
of the front log directly above the front burner. Use
a small pocket knife or micro screwdriver to pierce
the log and “embed” the metallic wool fibers into the
log material (pierce the log approximately 1/8”).
Pull the material away to leave a few strands
embedded into the log.