Avalon Firestyles DVL Fireplace-1999 to 2002 - Manual (Page 38)

3 6
Operation
Travis Industries 4 0 2 0 8 1 2 9 3 5 0 8 1 1 0
Before You Begin
Warning: Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 2 & 3). Failure to follow the instructions may result in property
damage, bodily injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of
the glass should be done by a licensed or qualified service person.
Location of Controls - See explanation below
Swing the control cover down
to access the gas control valve,
igniter, and blower control.
Gas Control
Valve
PILOT ADJ
VENT
T
O L PI
ON
OFF HI
LO
Gas Control
Knob
Flame Adjust
Knob
Blower Knob
BLOWER
LO
OFF
HI
PILOT
IGNITER
Pilot Igniter
ON/OFF Switch
The Pilot Flame can be found below
the back log on the left side.
ON
OFF
MAIN BURNER
Blower Knob This knob controls the speed of the internal convection blower that pushes
the heated air into the room.
On/Off Switch This control is used to turn the fireplace on and off.
Pilot Igniter The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
Gas Control Knob This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer directly below the
knob indicates the position this knob is in.
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The pointer
to the upper left of the knob points to the position this knob is in.
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the fireplace off always.