Avalon Firestyles DVL Fireplace-1999 to 2002 - Manual (Page 36)

3 4
Finalizing the Installation
(for qualified installers only)
Travis Industries 4 0 2 0 8 1 2 9 3 5 0 8 1 1 0
! We recommend you purge the gas line at this time (with the glass removed). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3 Replace the glass.
4 Install the faceplate.
! ACID WASH WARNING : Before installing the faceplate, make sure any masonry that has been
treated with acid wash has been properly neutralized (this is used primarily with brick faces). Acid wash
(muriatic acid) is used to remove excess mortar. If not properly neutralized with an ammonia solution,
the gold face may develop a permanent tarnish when the acid evaporates over time. Contact your
dealer if uncertain your facing has been properly neutralized.
5 Turn on the gas to the fireplace. Turn on gas to the heater. Leak test all gas joints prior to starting the
appliance. Start the pilot (see page 37). Start the main burner. Leak test all gas joints again.
6 Check the pilot flame to make sure it looks like the illustration below. Adjust the pilot flame if
necessary.
The pilot flame must contact the thermocouple and
thermopile (see the illustration below). Adjust the pilot up or
down as necessary.
PILOT ADJ
T
O L
PI
ON
OFF
Standard
Screwdriver
Micro (1/16”)
Standard
Screwdriver
Cover Screw
Cover Screw Gasket
Needle Valve
To adjust the pilot flame,
remove the cover screw
and gasket and turn the
needle valve (NOTE: if
the needle valve is totally
unscrewed, gas will come
out of this port).
Clockwise lowers the
flame while counter-
clockwise raises it.
Replace the cover screw
and gasket.