Avalon Firestyles B-Vent-1995 - Manual (Page 9)

S
TOVE
I
NSTALLATION
(C
ONT
.) -
For qualified installers only! P AGE 9
6 Slide the nine U-Nuts into place (see the illustration below).
7 Install the on/off switch (see the illustration below).
? If installing a thermostat or remote control, do so now.
8 Disconnect the power cord at the molex connector. Then insert the power cord through the rear
panel and re-attach to the molex connector leading from the heater (see the illustration below).
9 Attach the rear panel to the heater (see the illustration below).
Detach the two red wires leading to the on/off switch.
Insert the switch into the hole in the upper left of the rear
panel until it locks in place. Then re-attach the two red
wires from the heater to the upper two posts on the switch.
Slide the nine U-Nuts onto the holes
on the top and side panels (with the
flat portion out).
U-Nut
Back of Heater
Rear Panel
Disconnect the power cord at the molex connection and insert it
through the hole in the lower right of the rear panel. Then re-
attach the power cord to the heater.
Jumper Wire
(leave in place)
Attach the rear panel to the
heater with the twelve 10-24
self-tapping screws. Use a
5/16" nutdriver to tighten.
5/16" Nutdriver
Molex
Connection