Avalon Firestyles B-Vent-1995 - Manual (Page 40)

P AGE 40
O
PTIONAL
E
QUIPMENT
(C
ONTINUED
)
9 Replace the side glass but do not tighten it in place. Insert the center glass into position and
center it. Tighten the center glass clip nuts until the gasket starts to flatten, making sure the
gasket remains in place and is not pinched underneath the glass clip (use a 5/16" nutdriver).
Slide the side glass towards the center until the edge butts up against the center glass.
Tighten the side glass clip nuts until the gasket starts to flatten, making sure the gasket
remains in place and is not pinched underneath the glass clip (use a 5/16" nutdriver).
10 At this point the heater may be installed.
11 Fill in the PRA form included with this kit. Remember to include the serial number of the
heater. Then ship it, along with the un-burned NG burner pan, to Travis Industries for credit.
¥ No credit will be issued if the NG burner pan is damaged, incomplete, or if it was burned.
¥ Incomplete PRA forms will delay credit.
Disconnect the burner pan molex connector
Front of Heater
(with door &
glass removed)
NG Burner Pan
Phillips
Screwdriver
Place the LP label over
the left side of the serial
number label, replacing
the NG designation with
LP.
Remove the five screws
to detach the burner pan.
Then lift it up and rotate it
forward to remove.