Avalon Firestyles B-Vent-1995 - Manual (Page 38)

P AGE 38
O
PTIONAL
E
QUIPMENT
(C
ONTINUED
)
Thermostat
(Part # 99300650)
! Do not connect 110-120 VAC to the gas control valve or wiring of this unit.
1 The rear panel must be removed and the on/off switch installed prior to installing the remote control
(see page 9 for details). Remove and discard the jumper wire on the on/off switch Connect the two
female connectors on the thermostat wire to the two posts the jumper wire was attached to.
Remove the jumper
wire and discard.
Back of on/off switch
Rear Panel
Red wires leading
to the stove.
Attach the
thermostat
wires to the
bottom two
posts on the
on/off switch.
2 Route the remote control wire through
the gas inlet hole and pull through all
the slack (you may wish to wrap the
wire in electrical tape where it passes
through the heater to prevent damage
to the wire). Attach the rear panel
(see page 9 for details).
3 Choose a location for the thermostat
that is centralized in the room and
away from the heater, yet may be
reached with the 50' length of
thermostat wire. Route the thermostat
wire to this location. The wire may
be routed externally on the wall or
behind the wall (preferred).
4 Cut the thermostat wire so there is
approximately 6" of slack (NOTE: Do
not splice thermostat wires togetherÐ
this leads to too much electrical
resistance). Expose 1/2" off each wire
of the thermostat wire. Attach the
exposed wire to the clips on the back
of the thermostat using a screwdriver.
Run the thermostat
wire through the
wall (cut off
excess wire,
leaving 6" of slack)
Expose 1/2" of
wire and attach
to the two
connections on
the back of the
thermostat (use a
screwdriver).
Orientation does
not matter.
Wall
Back Side of
Thermostat
Pull the cover off the
thermostat to expose the
holes for mounting the
thermostat.
Use the appropriate screws to
mount the thermostat to the wall.
5 Pull the cover off the thermostat. Place the thermostat in location and attach it to the wall through
the two obround holes (use the appropriate screws for the type of wall it is being attached to).
Replace the cover on the thermostat to complete the installation.
Avanti Gold Trim
(Part # 99200116)
1 Install the stove shell prior to installing the
gold trim.
2 Place the pedestal trim against the pedestal.
Slide the trim until it is aligned. The magnets
on the back of the trim will hold them in place.
3 Remove the black grill from the upper stove
top. Replace with the gold grill.
! Do not pry the grill out Ð this may cause
chipping or cracking on enamel surfaces.
Remove the black grill and replace with
the gold grill (Do not pry the grill out Ð this
may damage the enamel surface).
The pedestal trim has
magnets on the back
side to hold it in place.