Avalon Firestyles B-Vent-1995 - Manual (Page 39)

O
PTIONAL
E
QUIPMENT
(C
ONTINUED
)
P AGE 39
Avanti LP (Propane) Burner Pan
(Part # 98900736)
The LP burner pan should be installed prior to installing the heater.
! Turn off the gas leading to the heater (if attached).
1 Remove the LP burner pan from the packaging and remove the two screws holding the
boxing brackets in place with a 5/16" nutdriver. Keep the packaging, boxing brackets, and
screws. They are used to ship the natural gas (NG) burner pan back to Travis Industries.
2 Remove the gold door from the heater (see step 1 on page 23).
Use a 5/16" nutdriver to remove
the two screws holding the
boxing bracket in place.
LP Burner pans have a
red mark here and an
"LP" stamped onto the
top of the burner pan.
5/16" Nutdriver
Boxing Bracket
Burner Pan
Molex
Connector
LP Burner Pan
3 Remove the center glass (see step 2 on page 23). Each side piece of glass is held in place
with three glass clips. Loosen the nuts holding the clips in place two turns (there are six nuts
on each side). Then slide both pieces of glass out.
4 Disconnect the burner pan molex connector (see the illustration on the following page).
5 Using a phillips-head screwdriver, remove the 5 screws holding the natural gas (NG) burner
pan in place. Lift it up and rotate it forward to remove it from the firebox. Attach the boxing
brackets to it with the screws removed in step 1 and place it inside the LP burner pan
packaging.
6 Place the LP label over the left side of the serial number label, thus replacing the NG
designation with the LP designation (NOTE: this label is attached by a chain to the heater -
see the illustration on the following page).
7 Install the LP burner pan by rotating it into position. Replace the five screws removed in step
5 and tighten with a phillips-head screwdriver.
8 Re-connect the burner pan molex connector disconnected in step 4.