Avalon Firestyles B-Vent-1995 - Manual (Page 10)

P AGE 10
S
TOVE
I
NSTALLATION
(
CONT
.) -
For qualified installers only!
10 Pull gently on the power cord to take out any extra slack. Replace the strain relief and push it
into the hole in the rear panel (see the instructions under step 1 above).
11 Attach the control cover by sliding it over the attachment hooks. Place the black grill in place.
The control cover hangs on two sets of hooks on both sides. Align
the control cover and slide the bracket onto the hooks and then
move downwards.
Bracket on
Control Cover
Hooks on Side of Heater Control Cover
Installing the Gas Inlet
¥ Locate the 17-1/4" gas
inlet pipe included with
the heater (the shorter
one may be discarded).
Apply thread sealant to
one end and insert it
through the rear panel
and into the 90
°
elbow
on the gas control valve.
Tighten with a pipe
wrench.
! Leak check all gas line
connections.
Rear Panel
Gas Inlet
(3/8" diameter pipe)
17-1/4"
NOTE:
Apply thread sealant
prior to installing.