Avalon Firestyles B-Vent-1995 - Manual (Page 7)

S
TOVE
I
NSTALLATION
(C
ONT
.) -
For qualified installers only! P AGE 7
Stove Panel Assembly
1 Remove the strain relief that holds the power cord in place. It can be found on the convection panel
at the rear right of the stove.
Strain Relief
Power Cord
Compress the strain relief
from the top and bottom
with a pair of slip joint
pliers. Once compressed,
the strain relief can be
pulled out.
TO REMOVE THE STRAIN RELIEF
Compress the strain relief
from the top and bottom
and insert it into the hole
until it locks in place.
TO INSTALL THE
STRAIN RELIEF
2 The side convection plates are removed on the freestanding model. Use a 7/16" nutdriver to remove
the two nuts holding the right convection plate in place (save these nuts, they will be used to attach
the stove shell). Use a 1/4" nutdriver to remove the screw above the right convection plate. Pull the
plate up and away while threading the power cord through the plate. Set the plate near the stove and
disconnect the molex connector that attaches the power cord to the stove. Thread the power cord out
of the plate and place aside. Remove the left side convection plate (it is removed in the same manner
but does not have a power cord). Discard both convection plates.
Thread the power cord
through the right side
convection plate.
Remove this screw
with a1/4" nutdriver.
Remove these two nuts
with a 7/16" nutdriver
(set these nuts aside -
they are used later).
Disconnect the molex
connection to remove the
power cord (set the power
cord aside - it is used later).
Right side convection plate.
Make sure these wires
are not damaged (they
lead to the on/off switch)
NOTE: remove the left
side convection plate as
well.