Avalon Firestyles B-Vent-1995 - Manual (Page 17)

I
NSERT
I
NSTALLATION
(C
ONT
.) -
For qualified installers only! P AGE 17
Switching the Power Cord to the Left Side
+ The power cord may be routed to the left side. To do this, follow the directions below.
1 Remove the strain relief on the right side of the heater (see the illustration below). .
2 Use a 7/16" nutdriver to remove the two nuts holding the right convection plate in place (see the
illustration on page 7 under step # 2). Use a 1/4" nutdriver to remove the screw above the right
convection plate. Pull the plate up and away while threading the power cord through the plate. Set
the plate near the stove and disconnect the molex connector that attaches the power cord to the stove.
3 Thread the power cord out of the right side convection plate. Insert it through the left side
convection plate and re-attach the molex connector. Replace the right side convection plate.
4 Pull on the power cord to take out extra slack. Replace the strain relief in the left convection panel.
Strain Relief
Power Cord
Compress the strain relief
from the top and bottom
with a pair of slip joint
pliers. Once compressed,
the strain relief can be
pulled out.
TO REMOVE THE STRAIN RELIEF
Compress the strain relief
from the top and bottom
and insert it into the hole
until it locks in place.
TO INSTALL THE
STRAIN RELIEF
Insert
Placement
The Insert Must be
Placed 11-3/8" into
the Fireplace.
Disconnect the on/off switch from
the two red wires and run the two
red wires to the right side of the
insert along the facing. Keep the
green jumper wire attached to the
on/off switch.
Run the power cord to
either side of the insert
along the facing.
The insert must be in place with
the gas line and vent attached
prior to installing the panels.
Min. 27-3/4" WIde (includes 6" for gas
line installation)
Min. 22-3/8" Tall
(includes 2" for
vent installation)
See the section "Installing
the Gas Inlet" for details on
the gas inlet location.