Auto-Zone Control Systems Auto-Zone Basic Systems Installation & Operation (Version 02C) - Manual (Page 73)

Auto-Zone Basic Section 3
Programming 3-5
Zone Manager Status
Screens
To see the Zone Manager status, press the "C" key while the Main Screen is active. The
following screens will appear. Step to each additional screen by pressing the "#" key.
Press the "A" key to exit before all status screens have been viewed.
Status Screen #1
Status Screen #2
Line 2 - Current Supply Air Temperature
Line 3 - If the system is configured for VAV operation, this
line shows the current Static Pressure in the duct. It
is displayed in Inches of Water Column.
Line 4 - If the system is configured for VAV operation, this
line shows the current Bypass Damper position
currently required to maintain the displayed amount
of Static Pressure.
HVAC Status
Supply Air 78.6
Static Press 0.49
Bypass Damper 24%
Line 2 - Current Return Air Temperature
Line 3 - Current Outdoor Air Temperature
Line 4 - Current Economizer Damper Position if the system is
configured for Economizer control.
HVAC Status
Return Air 75.3
Outdoor Air 70.2
Economizer 20%