Auto-Zone Control Systems Auto-Zone Basic Systems Installation & Operation (Version 02C) - Manual (Page 119)

Auto-Zone Basic Section 4
Start-Up & Troubleshooting 4-17
Bypass Calibration
Please Wait...
Initializing Zones
Vent Mode
03/27/02 09:30pm Wed
Occupied
1 Alarm(s) 3
3.) At the conclusion of the 50 second startup delay, the
system proceeds with the bypass damper calibration.
Depending on the degree of travel and the speed of the
damper actuator, this process could take up to a maxi-
mum of three minutes.
4.) The zones are all polled and initialized.
5.) The Main Operating Screen will now appear (see Sec-
tion 3, LCD/Keypad Operations) and normal operation
will begin. The total startup time is approximately four
minutes.