Artesyn COMX-P40x0 ENP2 Installation and Use (January 2015) - Manual (Page 25)

Chapter 1
COMX-P40x0 ENP2 Installation and Use (6806800R95C) 25
Introduction
1.1 Overview
The COMX-P40x0-ENP2 is a COM Express module based on the Freescale QorIQ™ processors
on convenient pluggable mezzanine modules that is suitable for use in extended temperature,
rugged environments. The COMX-P40x0 module provides a high-performance, feature-rich
solution for current and future generations of embedded applications.
Following are the features of the COMX-P40x0 ENP2 module:
 Supports Freescale QorIQ P4040 or P4080 processors
 Form Factor: Basic (95 mm x 125 mm)
 Memory: 2 GB or 4 GB soldered-down DDR3-1333 with ECC
– Designed to support up to 8 GB of DDR3
 Sixteen configurable SerDes lanes routed to COM Express connectors. Available interfaces
include: PCIE, XAUI, SRIO, SGMII
 On-board Storage:
– 16bit NOR FLASH from local bus (standard product default)
– NAND FLASH from local bus
– I2C EEPROM
Note: Selectable via carrier
 Software: Demo, runtime Linux Operating System and filesystem(s), pre-installed in
NOR/NAND Flash.
I/O Connectors:
 Four UART ports
 One Gigabit Ethernet interface (10/100/1000Base-T)
 Four USB ports
 IEEE 1588 control
 Three I
2
C bus
 Eight GPIO ports
 SPI bus with four chip select signals