Artesyn COMX-P4080 Installation and Use (August 2014) - Manual (Page 40)

Hardware Preparation and Installation
COMX-P4080 COM Express Module Installation and Use (6806800L20C) 40
7. Press down on the memory module against the COM-E module until you hear it snap into
place. The module must be properly aligned before you press it down into its final position.
You can remove the module from the socket and reinstall it if you cannot press it down into
its final position.
Removing a Memory Module
1. Wear the ESD-preventive wrist strap.
2. Release the module from the slot by pushing the spring latches on either side of the module
outward.
3. Lift the module from the COM-E Module.
2.5 Installing and Removing the Heat
Spreader/Cooler
Installing the Heat Spreader/Cooler
1. Check the thermal interface material pads on the heat spreader/cooler. Make sure the pads
are aligned to their corresponding components on the COMX-P4080 COM Express Module.
2. Align the standoffs of the heat spreader/cooler with the screw holes on the COMX-P4080
COM Express Module.
Damage of the Product and Additional Devices and Modules
 Incorrect installation or removal of additional devices or modules damages the product
or the additional devices or modules.
 Before installing or removing additional devices or modules, read the respective
documentation and use appropriate tools.