Argox AS-9500 - Manual (Page 82)

81
MSI
MSI Check Character
Different types of check characters are used with MSI bar codes.
You can program the imager to read MSI bar codes with Type 10
check characters.
When Check Character is set to Validate and Transmit, the
imager will only read MSI bar codes printed with the specified
type check character, and will transmit this character at the end of
the scanned data. When Check Character is set to Validate, but
Don’t Transmit, the unit will only read MSI bar codes printed
with the specified type check character, but will not transmit the
check character with the scanned data.
Message Length
Scan the bar codes below to change the message length. Minimum
and Maximum lengths = 4-48. Minimum Default = 4, Maximum
Default = 48.
On
*Validate Type 10, but Don
’t
Transmit
Minimum Message Length
*Off
Validate Type 10 and Transmit
Maximum Message Length