Argox AS-9500 - Manual (Page 57)

56
Code 39
Start/Stop Characters
Start/Stop characters identify the leading and trailing ends of
the bar code. Youmay either transmit, or not transmit
Start/Stop characters. Default = Don’t Transmit.
Check Character
No Check Character indicates that the imager reads and
transmits bar code data with or without a check character
When Check Character is set to Validate, but Don’t Transmit,
the unit only reads Code 39 bar codes printed with a check
character, but will not transmit the check character with the
scanned data. When Check Character is set to Validate and
Transmit, the imager only reads Code 39 bar codes printed
with a check character, and will transmit this character at the
end of the scanned data. Default = No Check Character.
*On
Transmit
*No Check Character
Validate and Transmit
Off
*Don ’t Transmit
Validate, but Don ’t Transmit