Argox AS-9500 - Manual (Page 33)

32
of sensitivity (from 0-20) from the inside back cover, and Save. 0
is the most sensitive setting, and 20 is the least sensitive.
Default = 1.
Hands Free Time-Out
The Auto-sense Modes is referred to as “hands free” modes. If the
hardware trigger is pulled when using a hands free mode, the
imager changes to manual trigger mode. You can set the time the
imager should remain in manual trigger mode by setting the Hands
Free Time-Out. Once the time-out value is reached, (if there have
been no further trigger pulls) the imager reverts to the original
hands free mode. Scan the Hands Free Time-Out bar code, then
scan the time-out duration (from 0-300,000 milliseconds) from the
inside back cover, and Save. Default = 5,000 ms.
Read Time out
Read Time-Out
Low Power Time-Out
Auto-sense
*LEDs On
LEDs Off
LED Time-Out
LED Time-Out Duration
Hands Free Time-Out
Sensitivity