Argox AS-9500 - Manual (Page 127)

126
OCR Fonts
Default All OCR Settings turns off all OCR capability in the
imager, so the imager will be able to scan linear, stacked, matrix,
and composite bar codes, but not OCR fonts. In addition, any OCR
templates you have created are erased.
The eight digit default templates are reinstated for any future use
of the OCR On codes listed below.
OCR
Note: OCR symbols can misread when scanned sideways or
upside down. Use Working Orientation , if your OCR symbols will
not usually be presented upright to the scanner. Only one OCR
symbology can be read at a time.OCR-A On allows you to scan
characters in the OCR-A font. The default setting allows you to
scan any eight digit combination. If you have created an OCR
template, character combinations that fit the template can be
scanned. OCR-B On allows you to scan characters in the OCR-B
font. The default setting allows you to scan any eight digit
combination. If you have created an OCR template, character
combinations that fit the template can be scanned.
OCR-A On
OCR-B On