Argox AS-9500 - Manual (Page 30)

29
Scan
Auto-sense Mode
This programs the imager to work in Auto-sense mode. The LEDs
are either off or at the lowest power for ambient conditions until a
bar code is presented to the imager. Then the LEDs turn on
automatically to read the code. Auto-sense Mode uses ambient
light to detect the bar codes. If the light level in the room is not
high enough, Auto-sense Mode may not work properly.
Snap and Ship
Snap and Ship mode allows you to bypass the decoder and ship an
image directly to the host. In this mode, an image is taken and
shipped upon each trigger pull, instead of being sent to the decoder.
Snap and Ship is useful when you are using your own decoder.
Note: Snap and Ship mode only works if the imager is connected
via an RS-232 serial port or via a USB keyboard. If you use Snap
and Ship when the imager is connected to another interface, it calls
the decoder after each image ship, but only to look for menu
codes.