Adept EX SmartContoller - Manual (Page 78)

Chapter 6: sDIO Module
The X1 and X2 output connectors are also similar except that X1 handles the group 1 and
group 2 output signals and X2 handles the group 3 and group 4 output signals. The optional
digital output cables can be connected to either X1 or X2. Make sure to clearly label the cables
once you have completed your installation so that the cables do not get swapped by mistake.
See the warning that follows.
WARNING: Clearly label the X1 to X4 digital I/O cables so that they are
always plugged into the correct connectors. Swapping the X3 and X4 or
X1 and X2 cables could cause damage to your equipment. Depending on
the installation, this could potentially cause injury to personnel in the area.
Input and Output Cable Wiring Information
The pinouts, signal names, and wire color information for the input and output cables are
shown in the next four tables.
Adept SmartController EX User’s Guide, Rev. B
Page 78 of 96