beautypg.com

Adept EX SmartContoller User Manual

Page 22

background image

Chapter 2: Installation

NOTE: The power requirements for the user-supplied power supply will vary depending on the
configuration of the Adept SmartController EX motion controller and connected devices. A mini-
mum configuration of the controller, front panel, and pendant will require 2 A at 24 VDC. How-
ever, a 24 V, 5 A power supply is recommended to allow for additional current draw from
connected devices, such as external IEEE 1394 devices and digital I/O loads.

24 VDC Power Cabling

In order to maintain compliance with many standards, DC power must be delivered over a
shielded cable, with the shield connected to the frame ground at both ends of the cable, as
shown in the following figure. Conductors should be 1.5 mm

2

- 1.85 mm

2

(16 to 14 AWG) in

size. The maximum length for the 24 VDC cable is 10 meters.

-

+

-

+

User-Provided
Power Supply
24 VDC, 5 A

Optional
Fuse

Adept SmartController EX
Motion Controller

User-Supplied Shielded
Power Cable

Note: Use connector
supplied by Adept at
this end of cable.

Shield from cable
Star washer
M3 x 6 screw

Shield from cable to frame
ground on power supply

Circuit protection < 8A

Frame Ground

Figure 2-7. User-Supplied Power Cable

Daisy-Chaining Power

The Adept SmartController EX motion controller is equipped with two DC power connectors.
These connectors allow the daisy-chaining of power from one controller to another or to an
sDIO module. When daisy-chaining power, the power supply circuit must be limited to the
lesser of 8 Amps or the ampacity of the cabling. This can be done with a circuit breaker or a
fuse. The DC power can be applied to either the XDC1 or XDC2 connector.

CAUTION: Use only one 24 VDC power supply per circuit. Failure to do
this could result in damage to the equipment.

CAUTION: The SmartVision EX vision controller has a higher current
demand and should be wired independently. Do not daisy-chain its
power from a Adept SmartController EX motion controller.

Adept SmartController EX User’s Guide, Rev. B

Page 22 of 96